300Tdi Discovery
75
SUPPLEMENTARY RESTRAINT SYSTEM
14
REPAIR
AIRBAG HARNESS
Service repair no - 86.70.63
Remove
1. Remove driver’s airbag.
See driver’s airbag
module.
2. Remove passenger’s airbag.
See passenger’s
airbag module.
3. Remove dash panel assembly.
See CHASSIS
AND BODY, Repair, dash panel assembly
4. Remove heater blower unit.
See HEATING
AND VENTILATION, Repair, blower motor
unit - heater and air conditioning.
5. Remove heater and cooler unit.
See AIR
CONDITIONING, Repair, heater and cooler
unit
Pre 97 MY
6. Remove 3 screws securing expansion tank and
position expansion tank aside.
7. Disconnect multiplug from each crash sensor.
8. Release airbag harness from clips and ties along
the bulkhead and each valance.
9. Displace airbag harness grommet to inside of
bulkhead and feed harness through bulkhead.
All Models
10. Disconnect multiplug from airbag control unit.
11. Release airbag harness from under carpet.
12. Release ties securing harness along toeboard.
13. Disconnect steering wheel airbag multiplug.
14. Release airbag harness from driver’s side and
remove.
Refit
15. Reverse removal procedure.
CAUTION: Ensure harness is correctly
routed in harness protector and that all
securing clips and ties are correctly
engaged and harness is undamaged. Ensure all
connections are fully engaged and retained by
their latches.