300Tdi Discovery
76
CHASSIS AND BODY
34
REPAIR
SILL FINISHER
Service repair no - 76.76.05
Remove
1. Remove the nut, bolt and washer securing the
front of the sill finisher to the wing [fender]
support bracket.
2. Remove the screw securing the bracket at the
rear end of the finisher to the sill.
3. Using a suitable punch, remove the inserts from
the seven plastic retainers and withdraw the
finisher from the sill.
Refit
4. Reverse removal procedure. Using new plastic
retainers.
BONNET [HOOD]
Service repair no - 76.16.01
Remove
1. Open the bonnet [hood] and support with the
stay.
2. Mark the position of the hinges to the bonnet
[hood].
3. With the assistance of a second operator,
remove the hinge to bonnet [hood] securing
screws, remove the support stay and lift bonnet
[hood] from the vehicle. Note the quantity of
shims fitted between the hinge and bonnet
[hood].
Refit
4. Reverse removal procedure. Ensuring that it
aligns with the wings [fenders], cowl panel and
front grille before fully tightening the securing
bolts.