Discovery I (LJ) V8-4.0L (1996)
7. Allow primer to dry as follows:
^ 285-50 - For 3 hours at 68°F
^ 285-95 - For 4 hours at 68°F
or force dry for 40 minutes at 120°F
8. Wet sand primer after drying time with 400/600 (P800-P1200) grit paper.
9. Wet sand entire area to be painted with 400/600 (P800-P1200) grit paper
PAINTING PROCEDURE
NOTE: Ten percent base coat activator (355-55) should be added to the base coat to ensure maximum stone chip resistance.
1. Mix base coat as follows:
^ 100 parts by volume of base coat 55 Line
^ 40 parts by volume of reducer 352-50,91
^ 10 parts by volume of 355-55
2. Apply two coats of 55 Line" base coat to the entire area allowing three to five minutes between coats.
3. Allow basecoat to flash 10 minutes or until matte.
CAUTION: Elastifier must be added to clear coat before hardener.
4. Elastify clear coat 25% by volume (4:1 ratio)
5. Apply 2 coats of elastified clear coat allowing two to three minutes flash between coats.
CAUTION: Plastic parts can deform during baking if not supported properly. If parts are removed from the vehicle use a lower force dry
temperature (120°F for 40 minutes)
6. Force dry at 140°F for 30 minutes.
CAUTION: Allow 24 hours drying time before attempting to polish to remove dirt nibs or similar imperfections.
7. Polish surface as required after 24 hour drying time.