Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - L Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - K Series12 Cooling system - L Series13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Transfer box - IRD17 Drive shafts18 Rear axle and final drive19 Steering20 Front suspension21 Rear suspension22 Brakes23 Restraint systems24 Body25 Heating & ventilation26 Air conditioning27 Wipers & washers28 Electrical29 Instruments
Land Rover Freelander Workshop Manual (1998-2000)02 · General information
02 · General

Precautions against damage

Make
Land Rover
Model
Freelander Workshop Manual
Year
1998–2000
Section
General precautions and fitting instructions › Precautions against damage
General informationPrecautions against damage

Precautions against damage

CAUTION: Always fit wing and seat covers before commencing work. Avoid spilling brake fluid or battery acid on paintwork; immediately wash off with water if this occurs.

CAUTION: Disconnect the battery earth lead before starting work, see ELECTRICAL PRECAUTIONS.

CAUTION: Always use the recommended service tool or a satisfactory equivalent where specified.

CAUTION: Protect exposed bearing surfaces, sealing surfaces and screw threads from damage.

SAFETY INSTRUCTIONS

Whenever possible, use a lift or pit when working beneath vehicle, in preference to jacking. Chock wheels as well as applying parking brake.

Jacking

The recommended jacking points are shown in the LIFTING AND TOWING sub-section of the INFORMATION section. Always ensure that any lifting apparatus has sufficient load capacity for the weight to be lifted.

Ensure the vehicle is standing on level ground prior to lifting or jacking.

Apply the handbrake and chock the wheels.

WARNING: Never rely on a jack as the sole means of support when working beneath the vehicle. Use additional safety supports beneath the vehicle.

Do not leave tools, lifting equipment, spilt oil, etc., around or on the work bench area. Always keep a clean and tidy work area.

Brake shoes and pads

WARNING: Always fit the correct grade and specification of brake linings. When renewing brake pads and brake shoes always replace as complete axle sets only.

Parts & tools for this job For 1998 Land Rover Freelander

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.