Oil seal - differential (page 2 of 2)

Refit

1. Clean oil seal recess.
2. Fit new oil seal using LRT-51-012.
3. Clean drive shaft end and differential oil seal.
4. Lubricate oil seal running surfaces.
5. Check condition of oil seal ’Flinger’, renew if damaged and fit onto drive shaft.
6. Fit new circlip to drive shaft.
7. With assistance fit drive shaft to differential, push fully home to engage circlip.
8. Fit nut and bolt to adjustable transverse link and tighten to 120 Nm.
9. Fit nut and bolt to fixed transverse link and tighten to 120 Nm.
10. Fit nut and bolt to trailing link and tighten to 120 Nm.
11. Fit road wheel(s) and tighten nuts to correct torque. See INFORMATION, Torque wrench settings.
12. Remove stand(s) and lower vehicle.
13. Check differential oil level. See MAINTENANCE.