Freelander Service Procedures
ENGINE - K SERIES KV6
12-3-30 REPAIRS
46. Remove nuts securing RH and LH track rod
end ball joints.
47. Fit an M12 nut to each ball pin, flush with end of
each pin.
48. Using LRT-57-043, separate ball pins from RH
and LH steering arms. Remove M12 nuts and
release ball pins from steering arms.
49. Pull RH and LH hubs outwards and release
driveshafts from hubs.
50. Using LRT-54-026, release drive shafts from
IRD unit and gearbox.
51. Remove nut securing selector lever to selector
shaft on gearbox and release lever from
selector shaft.
52. Release clip securing selector cable to gearbox
bracket, remove cable and tie aside.
53. Using a 3/8” square drive socket bar, raise
ancillary drive belt tensioner and release drive
belt from A/C compressor pulley.
54. Disconnect multiplug from A/C compressor.
