Remove & Refit Heater Unit/HEVAC - Improve Heating & Ventilation - Range Rover L322
HEATING AND VENTILATION
REPAIRS
80-5
7. Remove 3 screws securing air intake cover and
remove cover.
8. Remove air filter.
Refit
1. Fit air filter.
2. Fit plenum cover and secure with screws.
3. Fit plenum assembly and tighten nuts to 10 Nm
(7 lbf.ft).
4. Fit positive cable to stud and tighten nut to 20
Nm (15 lbf.ft)
5. Fit cover.
6. Fit bonnet sealing rubber to air intake moulding.
7. Connect battery earth lead.
8. Reconnect support stays and close bonnet.
Heater unit/HEVAC - remove for access
& refit
$% 80.20.01.99
Remove
1. Remove glove box assembly.
Glove box assembly removal is necessary to
access fascia harness retaining screws.
2. Remove fascia.
Fascia - remove for access & refit.
3. Disconnect multiplug and remove air blend
motor.
4. Remove Torx screws and nuts from rear of
fascia harness tray. Release clips to allow
movement of harness for access. Do not cut
harness tray cable ties.