LR3/Disco 3
Stabilizer Bar Link (64.35.24)
Removal
Installation
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the wheel and tire.
3 .
CAUTION: Use a wrench on the hexagon provided to prevent the ball joint rotating.
Remove the stabilizer bar link.
1 .
Install the stabilizer bar link.
Tighten the nuts to 115 Nm (85 lb.ft).
2 .
Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (103 lb.ft).