Rear Suspension: Upper Arm Replacement Procedures
Installation
Mark the position of the bolt in relation to the upper arm.
Remove the nut and bolt, then release the upper arm from the wheel knuckle.
Remove the upper arm bolts.
1 .
Install the upper arm.
Fit the bolts but do not fully tighten at this stage.
2 .
Set the height between the center of the halfshaft end and the edge of the fender trim to 485 mm
(19.10'').
Support with an axle stand.
3 .
CAUTION: Ensure the ball joint seal is not damaged. A damaged seal will lead to the premature
failure of the joint.
Connect the upper arm and wheel knuckle.
