LR3/Disco 3
9. Install the wheel nuts.
10. Rotate the brake disc one revolution to measure the brake disc run -out.
11. If the brake disc run-out is outside the limit. Remove the brake disc.
12. Make sure the brake disc and hub mating surfaces are clean.
13. Install the brake disc.
14. Install the wheel nuts.
15. Rotate the brake disc one revolution to measure the brake disc run -out.
16. If the brake disc run-out is still outside the limit, install a new brake disc and/or hub.
17. Remove the dial indicator gauge and the special tool.
l
Install spacer washers under the wheel nuts.
l
Tighten the wheel nuts to 140 Nm (103 lb.ft).
l
Brake disc run-out must not exceed 0.3 mm.
l
Tighten the Torx screw to 35 Nm (26 lb.ft).
l
Install spacer washers under the wheel nuts.
l
Tighten the wheel nuts to 140 Nm (103 lb.ft).
l
Brake disc run-out must not exceed 0.3 mm.