LR3/Disco 3
CAUTION: Make sure the timing blade on the high-pressure pipe union is correctly seated.
Connect the power steering high-pressure pipe union.
Remove the blanking caps from the ports.
Install new sealing washers.
Tighten the union to 25 Nm (18 lb.ft).
Remove the container.
6 .
Connect the charge air cooler inlet hose.
Tighten the clips.
7 .
Secure the charge air cooler inlet pipe.
Install the two retaining bolts.
Install the retaining nut.
Tighten to 10 Nm (7 lb.ft).
8 .
Install the upper suspension arm and brake line heat shields.
9 .
Install the front LH fender splash shield. For additional information, refer to
Fender Splash Shield
(76.10.48)
(Section 501-02)
10 .
Install the wheel and tire.
11 .
Install the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
12 .
Install the cooling fan shroud. For additional information, refer to
Cooling Fan Shroud (26.25.11)
(Section 303-03)
13 .
Check and top-up power steering fluid level. For additional information, refer to
Power Steering
System Filling and Bleeding
(Section 211-00)
14 .
Install the engine cover. For additional information, refer to
Engine Cover - 2.7L Diesel (12.30.50)
(Section 501-05)
15 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)