LR3/Disco 3
Installation
All vehicles
4 .
Remove the steering gear.
Remove the 2 bolts and discard the nuts.
1 .
Clean the component mating faces.
2 .
Install the steering gear.
Tighten the bolts to 175 Nm (129 lb.ft).
3 .
Connect the electrical connector.
4 .
Install the power steering fluid lines.
Clean the component mating faces.
Install new O-ring seals.
Install the clip.
Tighten the bolt to 22 Nm (16 lb.ft).
5 .
Secure the power steering line support mount.
Install the bolt and tighten to 10 Nm (7 lb.ft).
6 .
Connect the universal joint to the steering gear.
Install new patchlock bolt and tighten to 30 Nm (22 lb.ft).