LR3/Disco 3
1 .
Install the steering angle sensor.
Tighten the Torx screws to 3 Nm (2.2 lb.ft).
2 .
Install the ignition switch assembly.
Tighten the shear bolts until the heads shear off.
3 .
CAUTION: Make sure the bolt holes are clean and free of swarf.
CAUTION: The steering column bolts must by tighted by hand a minimum of 3 revolutions.
CAUTION: Air tools MUST NOT be used on steering column bolts.
With assistance, install the steering column.
Tighten the bolts in sequence to 25 Nm (18 lb.ft).
4 .
Connect the steering column intermediate shaft.
Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
5 .
Secure the wiring harness to the steering column.
6 .
Connect the steering column adjustment motor electrical connector.
7 .
Connect the steering angle sensor electrical connector.
8 .
Connect the passive coil electrical connector.
9 .
Connect the ignition switch electrical connector.
10 .
Install the steering column gaiter panel.
Secure with the clips.
Tighten the Torx screws.
11 .
Install the steering column switch assembly.