LR3/Disco 3
Installation
Remove the 8 bolts.
Collect the camshaft oil supply line.
14 .
Remove the camshaft.
1 .
Install the camshaft.
Clean the component mating faces.
Lubricate the components with clean engine oil.
2 .
NOTE :
Note the fitted position.
Install the camshaft bearing caps.
Clean the component mating faces.
Lubricate the components with clean engine oil.
3 .
NOTE :
After installing the bolts check the camshaft is free to rotate.
Install the camshaft oil supply line.
Thoroughly clean and inspect the oil supply line.
Prime the oil supply line with clean engine oil.
Tighten the bolts evenly in 2 stages to the sequence shown.
Tighten the bolts to 6 Nm (4 lb.ft).
Tighten the bolts to 16 Nm (12 lb.ft).
4 .
Clean the component mating faces.
5 .
Check cylinder head face for distortion, across the center and from corner to corner. For additional
information, refer to
Specifications
(Section 303-01)
6 .
CAUTION: The head gasket must be installed over the cylinder block dowels.
Install a new cylinder head gasket.