LR3/Disco 3
Install the cylinder head RH assembly.
Connect the cylinder head earth ground connector.
Tighten the bolt to 10 Nm (7 lb.ft).
8 .
NOTE :
Tighten the bolts 1 to 8 in the sequence shown. The M12 bolts are tightened in 3 stages.
Install the cylinder head bolts.
Lubricate the new cylinder head bolt threads with clean engine oil.
Tighten the M12 bolts to 30 Nm (22 lb.ft), then a further 80 degrees.
Tighten the M12 bolts a further 80 degrees.
Tighten the M8 bolts to 35 Nm (26 lb.ft).
9 .
Install the exhaust manifold. For additional information, refer to
Exhaust Manifold RH (30.15.11)
(Section 303-01)
10 .
NOTE :
The thread is left handed.
Install the camshaft sprocket bolt.
Remove and discard the cable tie.
Clean the component mating faces.
Install and lightly tighten the camshaft sprocket bolt.
11 .
Install the RH hydraulic timing chain tensioner.
Tighten the tensioner to 45 Nm (33 lb.ft).
12 .
Install the cylinder head coolant flange.
Clean the component mating faces.
Tighten the bolts to 10 Nm (7 lb.ft).
Secure the hose with the clip.
Connect the ECT sensor electrical connector.
13 .
Install the generator mounting bracket.
Clean the component mating faces.
Tighten the bolts to 45 Nm (33 lb.ft).
