LR3/Disco 3
Tighten the bolts to 10 Nm (7 lb.ft).
2 .
CAUTION: Care must be taken when removing sealant from gasket faces, prevent damage to
the mating faces.
NOTE :
The component must be installed within 20 minutes of the sealant application.
NOTE :
Make sure the cylinder block cradle gasket is located correctly around the front oil seal.
Install the engine front cover.
Clean the component mating faces.
Spirit wipe the gasket mating faces.
Install a new gasket.
Apply sealant to the 4 places shown.
3 .
NOTE :
Tighten the bolts in two stages.
Install the engine front cover bolts.
Evenly and progressively tighten the bolts and studs to 8 Nm (6 lb.ft).
Tighten the M6 bolts to 10 Nm (7 lb.ft).
Tighten the M8 bolts and studs to 20 Nm (15 lb.ft).
4 .
Install the transmission support bracket.
Tighten the nut to 20 Nm (15 lb.ft).
5 .
NOTE :
Care must be taken when installing the ground connections. The engine will fail to start on either or
both banks if the ground is poor.
Connect the engine ground cable, make sure the mating faces are clean.
Tighten the nut to 20 Nm (15 lb.ft).
6 .
Install the A/C compressor mounting bracket assembly.
Release the cable tie.
Tighten the bolts to 45 Nm (33 lb.ft).
7 .
Install the crankshaft pulley. For additional information, refer to
Crankshaft Pulley (12.21.01)
(Section
303-01)
8 .
Install the cooling fan shroud.
9 .
Install the intake manifold. For additional information, refer to
Intake Manifold (30.15.02)
(Section
303-01)
10 .
Refill and bleed the cooling system. For additional information, refer to
Cooling System Draining,