LR3/Disco 3
Installation
1 .
Install the engine mount.
Clean the component mating faces.
Tighten the new bolts to 45 Nm (33 lb.ft), then a further 60 degrees.
2 .
Install the engine mount bracket.
Clean the component mating faces.
Tighten the bolts to 80 Nm (59 lb.ft).
Remove the engine support.
3 .
Connect the starter motor cable.
Tighten the nut to 10 Nm (7 lb.ft).
Install the terminal nut insulator.
Install the cover.
4 .
Install the exhaust manifold. For additional information, refer to
Exhaust Manifold LH (30.15.10)
(Section 303-01)
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)