LR3/Disco 3
Installation
1 .
Install the engine mount.
Clean the component mating faces.
Tighten the new bolts to 45 Nm (33lb.ft), then a further 60 degrees.
2 .
Install the engine mount bracket.
Clean the component mating faces.
Tighten the bolts to 80 Nm (59 lb.ft).
Remove the engine support.
Tighten the nut to 90 Nm (66 lb.ft).
3 .
Install the exhaust manifold. For additional information, refer to
Exhaust Manifold RH (30.15.11)
(Section 303-01)
4 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)