LR3/Disco 3
Intake Manifold (30.15.02)
Special Service Tools
Fuel spring lock decoupling tool
310-044
Removal
NOTE :
Published : May 18, 2005
Removal of the intake manifold on early vehicles will involve the partial dismantling of the fuel rail and the removal
of the purge valve and mounting bracket. Once removed, it will also be necessary to remove some excess material
from the intake manifold, see 'installation' steps 1 and 2.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
2 .
Secure the hood in the service position.
Release the support struts.
3 .
Remove the engine cover. For additional information, refer to
Engine Cover - 4.0L (12.30.50)
(Section 501-05 Interior Trim and Ornamentation)
4 .
Remove the air intake resonator. For additional information, refer to
Intake Air Resonator (19.70.03)
(Section 303-12A Intake Air Distribution and Filtering - 4.0L)
5 .
Disconnect the throttle body electrical connector.
6 .
Disconnect the intake manifold coolant hose.
Clamp the relevant hose, to minimise coolant loss.
Release the clip.