LR3/Disco 3
Hydraulic Timing Chain Tensioner RH (12.65.66)
Removal
Installation
Published : Jun 30, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the engine cover. For additional information, refer to
Engine Cover - 4.0L (12.30.50)
(Section 501-05)
3 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Remove the RH hydraulic timing chain tensioner.
1 .
Install the RH hydraulic timing chain tensioner.
Clean the component mating faces.
Tighten the tensioner to 45 Nm (33 lb.ft).
2 .
Install the engine cover. For additional information, refer to
Engine Cover - 4.0L (12.30.50)
(Section
501-05)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)