LR3/Disco 3
Lubricate the components with clean engine oil.
2 .
NOTE :
The groove in the thrust plate must face the cylinder block.
Install the jackshaft thrust plate.
Clean the component mating faces.
Lubricate the components with clean engine oil.
Tighten the Torx bolts to 10 Nm (7 lb.ft).
3 .
Install the oil pump drive gear.
Clean the components.
Lubricate the components with clean engine oil.
Install a new O-ring seal.
Install the clamp.
Tighten the bolt to 20 Nm (15 lb.ft).
4 .
Install the camshaft drive cassette LH assembly. For additional information, refer to
Camshaft Drive
Cassette LH (12.65.36)
(Section 303-01)
5 .
Using the special tool, install the RH cassette jackshaft drive, sprocket bolt.
Clean the component mating faces.
Using the special tool, tighten the new jackshaft sprocket bolt to 40 Nm (30 lb.ft), then a
further 45 degrees.
6 .
Install the cylinder block jackshaft plug.
Clean the component mating faces.