LR3/Disco 3
Oil Pump (12.60.26)
Removal
Published : Jun 21, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
Remove the front wheels and tires.
4 .
Remove the cylinder block cradle. For additional information, refer to
Cylinder Block Cradle
(12.25.06)
(Section 303-01)
5 .
Remove the oil pump assembly.
Remove the 2 Torx screws.
Remove the driveshaft.
6 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the oil pickup pipe.
Remove the 3 Torx screws.
Remove and discard the seal.