LR3/Disco 3
Installation
1 .
Install the oil filler cap.
2 .
Install the engine breather valve.
Install a new O-ring seal.
3 .
Install the CMP sensor.
Install a new O-ring seal.
Tighten the bolt to 6 Nm (4 lb.ft).
4 .
Install the bolts and studs.
Install the new O-ring seals.
Install the new gasket.
5 .
Install the valve cover.
Clean the component mating faces.
Evenly and progressively tighten the bolts and studs, in the sequence shown, to 10 Nm (7
lb.ft).
Secure the electrical harness with the clip.
6 .
CAUTION: Make sure the knock sensor electrical harness is returned to the original fitted
position.
Install the injector harness.