LR3/Disco 3
Valve Cover RH (12.29.44)
Removal
Published : Jun 17, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the fuel rail. For additional information, refer to
Fuel Rail (19.60.04)
(Section 303-04)
3 .
Position the injector harness aside.
Release the 2 clips.
Disconnect the 3 fuel injector electrical connectors.
4 .
CAUTION: Before disconnecting or removing the components, ensure the area around the joint
faces and connections are clean. Plug open connections to prevent contamination.
Remove the valve cover.
Release the wiring harness retaining clip.
Remove the 2 bolts.
Remove the 4 studs.
5 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove and discard the gasket.
6 .
NOTE :