LR3/Disco 3
Installation
Note the fitted position.
Remove the bolts and studs. Remove and discard the seals.
1 .
Install the bolts and studs.
Install the new O-ring seals.
Install the new gasket.
2 .
Install the valve cover.
Clean the component mating faces.
Evenly and progressively tighten the bolts and studs, in the sequence shown, to 10 Nm (7
lb.ft).
Secure the electrical harness with the clip.
3 .
Install the injector harness.
Secure with the clips.
Connect the fuel injector electrical connectors.
4 .
Install the fuel rail. For additional information, refer to
Fuel Rail (19.60.04)
(Section 303-04)
5 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)