LR3/Disco 3
Engine (12.41.01.99)
Installation
Published : May 19, 2005
1 .
Remove the torque converter retainer.
2 .
Install the engine.
Connect the lifting chains.
Carefully lower the engine until approximately 35mm above engine mounts.
With assistance align the engine to the transmission and engine mounts.
3 .
Install the RH engine mount.
4 .
Install the transmission retaining bolts.
Clean the component mating faces.
Remove the guide pins.
Tighten the bolts to 45 Nm (33 lb.ft).
5 .
Tighten the engine mount nuts to 90 Nm (66 lb.ft).
6 .
Remove the engine lifting bracket.
Disconnect the lifting chains.
Remove the 7 bolts.
Remove the 12 nuts.
7 .
Attach the flexplate to the torque converter.
Rotate the crankshaft to access the retaining bolts.
Tighten the bolts to 45 Nm (33 lb.ft).
Install the grommet.
8 .
Connect the CKP sensor electrical connector.
Clean the component mating faces.
9 .
Connect the HO2S electrical connectors.
10 .
Install the engine wiring harness support bracket.
11 .
Connect the engine oil temperature sensor electrical connector.
12 .
Install the starter motor.
Clean the component mating faces.