LR3/Disco 3
Tighten the nut to 10 Nm (7 lb.ft).
23 .
Connect the engine ground cable, make sure the mating faces are clean.
Tighten the nut to 25 Nm (18 lb.ft).
Install the cover.
24 .
Install the A/C compressor mounting bracket assembly.
Clean the component mating faces.
Tighten the bolts to 45 Nm (33 lb.ft).
Install the KS electrical connector clip.
Connect the A/C compressor electrical connection.
25 .
Install the generator mounting bracket.
Clean the component mating faces.
Tighten the bolts to 45 Nm (33 lb.ft).
Secure the clip.
Install a new cable tie.
26 .
Connect the EOP sensor electrical connector.
27 .
Connect the generator electrical connectors.
28 .
Install the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
29 .
Install the cooling fan lower shroud.
Remove the radiator protection.
Position and secure in the clips.
30 .
Install the wiring harness to the plenum.
Secure with the clips.
31 .
Connect the ECM electrical connectors.
32 .
Install the battery tray. For additional information, refer to
Battery Tray (76.10.30)
(Section 414-01)
33 .
Install the intake manifold. For additional information, refer to
Intake Manifold (30.15.02)
(Section
303-01)
34 .
Tighten the nuts securing the EGR pipe to the exhaust manifold and EGR valve to 25 Nm (18 lb.ft).
35 .
Fill the engine with oil. For additional information, refer to
Engine Oil Draining and Filling (12.60.05)
(Section 303-01)