LR3/Disco 3
Tighten the bolts to 45 Nm (33 lb.ft).
13 .
Position the fuel pipe and purge line heat shield and secure with bolts.
14 .
Position the RH catalytic converter to the exhaust manifold.
Clean the components.
Tighten the new bolts to 22 Nm (16 lb.ft).
15 .
CAUTION: Make sure there is a clearance (A) of 25 mm to 30 mm between the closest points
of the LH catalytic converter and the front driveshaft.
Position the LH catalytic converter to the exhaust manifold.
Clean the components.
Tighten the new bolts to 22 Nm (16 lb.ft).
16 .
Install the transmission heat shield.
17 .
Connect the engine oil cooler hoses.
Secure with the clips.
18 .
Connect the coolant pump hose.
Secure with the clip.
19 .
Install the steering column lower universal joint assembly.
Install new patchlock bolts and tighten to 25 Nm (18 lb.ft).
20 .
Connect the ECT sensor electrical connector.
21 .
Install the EGR pipe.
Clean the component mating faces.
Install to the exhaust manifold, but do not fully tighten the union nut at this stage.
22 .
Install the transmission cooler pipes.
Install the support bracket.