LR3/Disco 3
information, refer to
Specifications
(Section 303-01C )
3 .
CAUTION: The head gasket must be installed over the cylinder block dowels.
Install a new cylinder head gasket.
4 .
NOTE :
Tighten the retaining bolts in the indicated sequence in four stages.
Install the RH cylinder head assembly
Install new cylinder head retaining bolts.
Tighten the bolts evenly in four stages to the sequence shown.
Stage one: Tighten to 20 Nm (15 lb.ft).
Stage two: Tighten to 40 Nm (30 lb.ft).
Stage three: Tighten to 80 Nm (59 lb.ft).
Stage four: Tighten a further 180 degrees.
5 .
Install the hydraulic adjuster and rocker assemblies.
6 .
Install the cylinder head coolant outlet elbow.
Install new O-ring seals.
Install the four retaining bolts and tighten to 10 Nm (7 lb.ft).
Connect the hoses and secure with the clips.
7 .
Secure the coolant bleed hose.
8 .
Secure the engine breather tube.
Tighten the bolt to 10 Nm (7 lb.ft).
9 .
Install the RH camshafts.
10 .
Install the RH exhaust manifold. For additional information, refer to
Exhaust Manifold RH (30.15.11)
(Section 303-01C Engine - 2.7L Diesel)
11 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00 Charging System - General Information)
