LR3/Disco 3
Installation
8 .
NOTE :
Some fluid spillage is inevitable during this operation.
Remove the oil cooler.
Remove the eight retaining bolts.
Remove and discard the gasket.
Remove and discard the O-ring seal.
1 .
CAUTION: Make sure the gasket is installed correctly.
NOTE :
Make sure all component mating faces are clean.
Install the oil cooler.
Install a new gasket.
Install a new O-ring seal.
Install the eight retaining bolts and tighten to 10 Nm (7 lb.ft).
2 .
Install the LH KS.
Install the retaining bolt and tighten to 20 Nm (15 lb.ft).
Connect the knock sensor electrical connector.
Attach the KS harness to the valve cover.
3 .
Install the cylinder head coolant outlet elbow.
Install new O-ring seals.