LR3/Disco 3
Installation
1 .
To install, reverse the removal procedure.
Install the coolant pump pulley.
Clean the component mating faces.
Install a new gasket.
2 .
Tighten the coolant pump retaining bolts.
Tighten to 10 Nm (7 lb.ft).
3 .
Tighten the coolant pump pulley retaining bolts.
Tighten to 25 Nm (18 lb.ft).
4 .
Install the power steering pipe.
Tighten the bolt to 10 Nm (7 lb.ft).
5 .
Install the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
6 .
Refill the cooling system. For additional information, refer to
Cooling System Draining, Filling and
Bleeding (26.10.01)
(Section 303-03)
7 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)