LR3/Disco 3
Coolant Pump (26.50.01)
Removal
Published : Jun 30, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
3 .
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do
not remove the filler cap from the coolant expansion tank while the system is hot.
Drain the cooling system. For additional information, refer to
Cooling System Draining, Filling and
Bleeding (26.10.01)
(Section 303-03)
4 .
Remove the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
5 .
Remove the bolt from the power steering pipe clip.
Position the pipe aside when removing the coolant pump.
6 .
Remove the coolant pump.
Disconnect the coolant rail hose from the coolant pump.
Remove the 12 bolts.
Discard the gasket.
7 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the coolant pump drive pulley.
Remove and discard the 4 bolts.
Remove the coolant pump capping hose.