LR3/Disco 3
Radiator (26.40.01)
Removal
NOTE :
Published : Jun 20, 2004
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove
the filler cap from the coolant expansion tank while the system is hot.
CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the
coolant and clean the area with water.
Always protect the cooling pack elements to prevent accidental damage.
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
3 .
Drain the cooling system. For additional information, refer to
Cooling System Draining, Filling and
Bleeding (26.10.01)
(Section 303-03)
4 .
Remove the viscous fan assembly. For additional information, refer to
Cooling Fan (26.25.19)
(Section 303-03)
5 .
Remove the radiator grille. For additional information, refer to
Radiator Grille (76.55.03)
(Section
501-08)
6 .
Remove the lower fan shroud.
Release the 4 clips.
Release the coolant hose.