LR3/Disco 3
Install a new gasket.
Loosely install the two EGR valve inlet tube retaining bolts.
8 .
Fully close the retaining clip.
9 .
Tighten the two LH EGR valve inlet tube retaining bolts to 10 Nm (7 lb.ft).
10 .
Install the turbocharger heat shield.
Remove the blanking caps from the ports.
Install new sealing washers.
Connect the turbocharger oil supply tube.
Tighten to 30 Nm (22 lb.ft).
Install the two retaining bolts.
Tighten to 10 Nm (7 lb.ft).
11 .
Install the upper suspension arm and brake line heat shields.
12 .
Install the height sensor link.
13 .
Attach the ABS sensor lead and brake pad wear indicator sensor lead to the body.
14 .
Install the wheel and tire.
15 .
Raise the vehicle.
16 .
Install the turbocharger oil return tube.
Remove the blanking caps from the ports.
Install a new gasket.
Tighten the two retaining bolts to 10 Nm (7 lb.ft).
17 .
Install the turbocharger oil return tube retaining bolt.
Install the retaining clamp.
Tighten to 10 Nm (7 lb.ft).
Install a new O-ring seal.
18 .
Reposition the oil level indicator tube.
Install a new O-ring seal.
Tighten to 10 Nm (7 lb.ft).
19 .
Tighten the turbocharger support bracket to cylinder block retaining bolts to 23 Nm (17 lb.ft).
20 .
Install the turbocharger support bracket.
