LR3/Disco 3
Installation
13 .
Remove the upper suspension arm and brake line heat shields for access.
14 .
Remove the EGR valve.
Remove the three retaining bolts.
1 .
Install the EGR valve.
Install the three EGR valve retaining bolts, but do not fully tighten at this stage.
2 .
NOTE :
Do not fully close the retaining clip at this stage.
Install the EGR valve inlet tube.
Install a new retaining clip.
Loosely install the two EGR valve inlet tube retaining bolts.
Install a new gasket.
3 .
Fully close the retaining clip.
4 .
Tighten the two EGR valve inlet tube retaining bolts to 10 Nm (7 lb.ft).
5 .
Tighten the three EGR valve retaining bolts to 10 Nm (7 lb.ft).
6 .
Install the upper suspension arm and brake line heat shields.
7 .
Install the wheel and tire.
8 .