LR3/Disco 3
Engine Oil Pressure (EOP) Sensor (12.60.50)
Removal
Installation
Published : Jul 12, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the engine cover. For additional information, refer to
Engine Cover - 2.7L Diesel (12.30.50)
(Section 501-05)
3 .
Disconnect the engine oil pressure (EOP) sensor electrical connector.
4 .
Remove the EOP sensor.
1 .
To install, reverse the removal procedure.
Tighten the EOP sensor to 15 Nm (11 lb.ft).
2 .
Check and top-up the engine oil.