LR3/Disco 3
3 .
Disconnect the low-pressure fuel lines.
Install blanking caps to the exposed ports.
4 .
Disconnect both exhaust gas recirculation (EGR) coolant cross-over pipe hoses.
Clamp the EGR coolant hoses to minimize coolant loss.
5 .
Remove the EGR coolant cross-over pipe.
Remove the two retaining bolts.
6 .
NOTE :
Left-hand shown, right-hand similar.
Release the RH and LH high-pressure fuel supply lines.
Remove the retaining bolt.
7 .
CAUTION: Make sure that the high-pressure fuel supply line remains in contact with the fuel
injection supply manifold and the fuel injection diverter rail until both unions have been detached and
cleaned. Failure to follow this instruction may result in foreign matter ingress to the fuel injection
system.