LR3/Disco 3
NOTE :
Left-hand shown, right-hand similar.
Remove and discard the RH and LH high-pressure fuel supply lines.
Install blanking caps to the exposed ports.
8 .
CAUTION: Make sure that the high-pressure fuel supply line remains in contact with the fuel
pump and fuel injection diverter rail until both unions have been detached and cleaned. Failure to
follow this instruction may result in foreign matter ingress to the fuel injection system.
NOTE :
Crankcase vent oil separator shown removed for clarity.
Remove and discard the high-pressure fuel supply line.
Install blanking caps to the exposed ports.
9 .
Release the low-pressure fuel line.
Disconnect the low-pressure fuel line.
Install blanking caps to the exposed ports.
10 .
Disconnect the fuel rail pressure (FRP) sensor electrical connector.
Release the fuel charging wiring harness.