LR3/Disco 3
Installation
1 .
Install the fluid pan.
Clean the components.
Install the seal.
Install a new O-ring seal.
Tighten the Torx screws to 8 Nm (6 lb.ft).
2 .
Lower the RH side of the engine.
Remove the engine support.
Tighten the nut to 90 Nm (66 lb.ft).
3 .
Install the transmission heat shield bracket.
Tighten the 4 bolts to 10 Nm (7 lb.ft).
Install the selector cable to its abutment bracket.
4 .
Install the selector cable to its abutment bracket.
5 .
Install the transmission heat shield.
Tighten the bolts to 10 Nm (7 lb.ft).
6 .
Install the transmission support insulator.
Clean the component mating faces.
Tighten the bolts to 60 Nm (44 lb.ft).
7 .
Install the exhaust system. For additional information, refer to
Exhaust System (30.10.08)
(Section
309-00)
8 .
Install the engine cover. For additional information, refer to
Engine Cover - 4.0L (12.30.50)
(Section
501-05)