LR3/Disco 3
Transmission Support Insulator (12.45.08)
Removal
Installation
Published : Jul 21, 2004
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the transmission crossmember. For additional information, refer to
Transmission Support
Crossmember (76.10.09 or 76.10.92)
(Section 502-02)
3 .
NOTE :
4.4L illustration shown, 4.0L and 2.7L Diesel are similar.
Remove the transmission support insulator.
Remove the 4 bolts.
1 .
To install, reverse the removal procedure.
Clean the component mating faces.
Tighten the bolts to 60 Nm (44 lb.ft).