LR3/Disco 3
3 .
Position the RH catalytic converter to the exhaust manifold.
Clean the components.
Tighten the new bolts to 22 Nm (16 lb.ft).
4 .
CAUTION: Make sure there is a clearance (A) of 25 mm to 30 mm between the closest points of
the LH catalytic converter and the front driveshaft.
Position the LH catalytic converter to the exhaust manifold.
Clean the components.
Tighten the new bolts to 22 Nm (16 lb.ft).
5 .
CAUTION: Make sure the H02S wiring harness is not twisted more than 180 degrees and is not
in contact with either the exhaust or driveshaft.
Connect the HO2S electrical connectors.
Attach the HO2S wiring harnesses.
6 .
Install the transmission crossmember. For additional information, refer to
Transmission Support
Crossmember (76.10.09 or 76.10.92)
(Section 502-02)
7 .
Install the engine undershield. For additional information, refer to
Engine Undershield (76.10.50)
(Section 501-02)
8 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)
