LR3/Disco 3
Glass Roof Panel (76.81.05)
Removal
NOTE :
Published : Apr 29, 2004
CAUTION: Always protect paintwork and glass when removing exterior components.
CAUTION: Always protect the interior components when removing body glass.
CAUTION: Lay the glass on felt covered supports. Do not stand on edge as this can cause chips which
subsequently develop into cracks.
The following equipment is required: l Cutting wire and handles l Kent knife l Glazing knife l Glass replacement kit l
Sealant applicator gun l Suction cups l A felt covered table or stand to support glass
1 .
Remove the headliner. For additional information, refer to
Headliner (76.64.15)
(Section 501-05)
2 .
Remove the roof moulding.
Release the 3 clips.
Repeat the above procedure for the other side.
3 .
Remove the antenna.
Disconnect the cable.
Remove the 2 screws.