LR3/Disco 3
2 .
Connect the door exterior handle mechanism cable to the door latch.
Connect the cable to the lever.
Secure the cable to the abutment bracket.
3 .
Install the remote control cable to the door latch.
Connect the cable to the lever.
Secure the cable to the abutment bracket.
4 .
Set the exterior handle mechanism.
Rotate the lever.
Engage the retaining tang.
5 .
Install the front door latch assembly.
Tighten the Torx screws to 10 Nm (7 lb.ft).
Connect the electrical connector.
6 .
Install the door exterior handle mechanism.
Position the mechanism to the door.
Fit the locking pin.
Fit and tighten the Torx screw.
7 .
LH side: Position the control cables into the retainers.
8 .
Position the remote control cable to the door.
Install the grommet.
9 .
Install the front door exterior handle. For additional information, refer to
Exterior Front Door Handle
(76.58.07)
(Section 501-14)
10 .
Install the window motor and regulator assembly. For additional information, refer to
Front Door
Window Regulator and Motor (86.25.03)
(Section 501-11)