LR3/Disco 3
Connect the hood release cable.
9 .
Install the radiator securing pegs.
10 .
Install the coolant expansion tank.
Position the coolant expansion tank, locate the spigot and lug.
Install the bolts and tighten to 10 Nm (7 lb.ft).
11 .
Install the windshield washer reservoir filler neck.
Locate in clip.
12 .
Install the power steering fluid reservoir.
Position and secure to mounting bracket.
13 .
Install the front bumper. For additional information, refer to
Front Bumper (76.22.49)
(Section 501-
19)
14 .
Open and close the hood to check the hood latch operation.
15 .
Adjust both of the hood latches.
Loosen the 4 hood latch Torx bolts.
Lower the hood and check for alignment.
Open the hood and tighten the Torx bolts to 10 Nm (7 lb.ft).
Check for the correct operation of the hood safety catch.
If necessary, repeat the above adjustment procedure.
16 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)