Range Rover P38
BMW DIESEL
27
REPAIR
30. Attach suitable lifting eye to upper rear inlet
manifold stud.
31. Attach hoist to lifting eyes. Remove cylinder
head, remove and discard LH rear cylinder head
bolt.
NOTE: 2 ring dowels locate cylinder head
to block.
CAUTION: To avoid damaging timing chain
guide, ensure cylinder head is lifted as
squarely as possible.
32. Remove cylinder head gasket.
33. Check number of thickness identification holes
before discarding gasket.
CAUTION: Check cylinder head for
warping, see Cylinder head warp check.
If crankshaft, pistons or connecting rods
have been renewed, new cylinder head gasket
thickness must be determined using the following
Piston Protrusion Check procedure. If above items
have not been disturbed, continue at Refit using
gasket with same thickness identification as
original.