Range Rover P38
30
MANIFOLD AND EXHAUST SYSTEM
NEW RANGE ROVER
18
REPAIR
18. Using the sequence shown, remove 12 bolts
securing inlet manifold.
19. Remove inlet manifold assembly.
20. Remove 2 bolts securing manifold gasket
clamps and collect gasket clamps.
21. Remove inlet manifold gasket.
22. Remove gasket seals.
Refit
23. Clean RTV from head and block notches.
24. Clean mating faces of block, head and manifold.
25. Apply RTV silicone sealant in the four ’V’ shaped
notches between the ends of the cylinder head
and the cylinder block joint.
26. Fit new gasket seals, ensure ends engage
correctly in notches.
27. Fit new manifold gasket.
28. Position gasket clamps, fit bolts but do not
tighten at this stage.
29. Position inlet manifold assembly.
NOTE: When fitting inlet manifold bolts,
tighten in reverse of removal sequence.
