Range Rover P38
ZF AUTO
31
REPAIR
4. Remove 6 bolts securing fluid pan to
transmission. Remove fluid pan. Collect retaining
plates.
5. Remove gasket and discard.
NOTE:
Do not carry out further dismantling if
component is removed for access only.
6. Remove bolt securing oil pick-up tube. Remove
pick-up tube. Collect spacer.
7. Remove remaining 2 bolts securing filter to valve
block. Remove filter.
8. Remove ’O’ rings and discard.
Refit
9. Ensure mating faces are clean.
10. Fit new ’O’ rings to fluid filter. Lubricate with
clean transmission fluid.
11. Position fluid filter. Secure with bolts. Tighten to
8 Nm (6 lbf.ft).
12. Position oil pick-up tube and spacer. Secure with
bolt. Tighten to
8 Nm (6 lbf.ft).
13. Fit new gasket to fluid pan. Position pan on
gearbox. Secure with bolts and retaining plates.
Tighten to
8 Nm (6 lbf.ft).
14. Up to 99MY: Fit oil filler tube. Tighten to
70 Nm
(52 lbf.ft).
From 99MY: Tighten forward bolt securing
snubber bar to cross member to
45 Nm
(33 lbf.ft).
15. Lower vehicle.
16. Refill transmission fluid.
See LUBRICANTS,
FLUIDS AND CAPACITIES, Information.
