Range Rover P38
44
AUTOMATIC GEARBOX
NEW RANGE ROVER
32
REPAIR
VALVE BODY ASSEMBLY
Service repair no - 44.40.01
Remove
1. Remove gearbox fluid filter.
See this section.
2. Remove 2 bolts securing speed sensor harness
bracket to valve block.
3. Disconnect multiplug from gearbox housing.
4. Using a 30 mm socket, remove nut securing
multiplug connector block from gearbox housing.
5. Remove 6 long bolts securing valve block to
gearbox.
6. Remove 5 short bolts securing valve block to
gearbox.
7. Release speed sensor and remove valve block.
8. Remove and discard ’O’ ring from multiplug
connector.
Refit
9. Clean valve block and mating faces.
10. Fit new ’O’ ring to multiplug connector block.
11. With assistance, position multiplug to gearbox
housing and tighten nut.
12. Align valve block to gearbox, ensure manual
valve is correctly located. Position speed sensor
retaining bracket, and tighten screws to
8 Nm
(6 lbf.ft).
13. Connect multiplug to gearbox connector.
14. Fit gearbox fluid filter.
See this section.