Range Rover P38
ELECTRICAL
57
REPAIR
13. Release LH rear HO2S multiplug from support
bracket.
14. Disconnect gearbox speed sensor multiplug.
15. Disconnect multiplug from transfer box High/Low
motor.
16. Disconnect 2 Lucars from transfer box oil
temperature sensor.
17. Disconnect multiplug from output shaft speed
sensor.
18. Open 3 harness support clips.
19. Remove gearbox harness from vehicle.
Refit
20. Position harness on top of gearbox.
21. Connect multiplug to output shaft speed sensor.
22. Connect 2 Lucars to transfer box temperature
sensor.
23. Connect multiplug to transfer box High/ Low
motor.
24. Fit and secure harness to support clips.
25. Fit LH rear oxygen sensor multiplug to support
bracket.
26. Connect multiplug to gearbox speed sensor.
27. Models with automatic gearbox: Fit selector
position switch multiplug to support bracket and
connect gearbox harness to selector position
switch multiplug.
28. Align multiplug bracket and selector cable
abutment bracket to gear box and secure with
bolts.
29. Raise gearbox on jack.
30. Push to locate handbrake cable grommet in
transmission tunnel.
31. Models with automatic gearbox: Fit gear
selector cable to abutment bracket and secure
with ’C’ clip.
32. Models with automatic gearbox: Fit selector
cable trunnion to lever and secure with split pin.
33. Models with automatic gearbox: Adjust gear
selector cable.
See AUTOMATIC GEARBOX,
Adjustment.
34. Clean exhaust front and intermediate pipe
mating faces.
35. Align intermediate pipe to front pipe and tighten
clamp nuts to
25 Nm (18 lbf.ft).
36. Fit chassis crossmember.
See CHASSIS AND
BODY, Repair.
37. Feed harness multiplug through tunnel. and
connect multiplugs to main harness.
38. Fit harness multiplug to tunnel.
39. Connect handbrake cable to lever, fit clevis pin
and secure pin with clip.
40. Fit centre console.
See CHASSIS AND BODY,
Repair.