Range Rover P38
STEERING
7
REPAIR
Refit
11. Position feed hose to vehicle.
12. Remove plugs from hose and PAS pump.
13. Clean hose and PAS pump union.
14. V8 up to 99MY: Connect feed hose union to
PAS pump and tighten to
16 Nm (12 lbf.ft).
V8 from 99MY and diesel: Connect feed hose
to pump using new sealing washers. Tighten
banjo bolt to
25 Nm (18 lbf.ft) (V8 models) or 30
Nm (22 lbf.ft) (diesel models).
15. Remove plugs from hose and steering box.
16. Clean hose and steering box union.
17. Position PAS hose brackets to steering box and
secure with nut.
18. Fit banjo bolt and new washers to feed hose and
fit to steering box. Tighten banjo bolt to
30 Nm
(22 lbf.ft)
19. Position feed hose and secure to radiator lower
bracket clips.
20. Bleed steering system.
See this section.
21. Remove stand(s) and lower vehicle.
STEERING BOX RETURN HOSE
Service repair no - 57.15.22
Remove
1. Disconnect battery earth lead.
2. Raise front of vehicle.
WARNING: Support on safety stands.
3. Position container to catch spillage.
4. Remove 2 bolts securing PAS fluid reservoir to
radiator bracket.
5. Remove clip securing return hose to PAS fluid
reservoir and disconnect return hose.
CAUTION: Plug the connections.
6. Position cloth to catch spillage.